Cisco Vpn Not Connecting Could Not Connect To Server

Posted on by



(with

I use Cisco AnyConnect on my Windows 7 computer to make VPN connections. It also has capability to connect to WiFi. But I always had problems in connecting toWiFi with AnyConnect. Connection drops frequently and it keeps saying ‘Acquiring IP address‘.

Connecting

Can't Connect To Vpn Cisco

AnyConnect installs a service called ‘Network Access Manager‘ which seems like takes over the native Windows WiFi connecting client. So when I click on the network icon in the System tray it says ‘No connections are available'(See below snapshot). Without AnyConnect, it always displays the WiFi connections available.

Hello, When I try to connect with AnyConnect, I receive the notification 'Could not connect to server. Please verify Internet connectivity and server address'.

  • Dec 26, 2013 Probably the routes on the mac that are not set. If you open a terminal and type in netstat -r, you should see if there is a route to your internal network through the vpn connection. If not, you need to set it. Could be that the vpn client isn't configured correctly or is unable to set the route. Command to set the route is: route -n add -net.
  • See full list on cisco.com.
  • Probably the routes on the mac that are not set. If you open a terminal and type in netstat -r, you should see if there is a route to your internal network through the vpn connection. If not, you need to set it. Could be that the vpn client isn't configured correctly or is unable to set the route. Command to set the route is: route -n add -net.

If you are facing the problem then you can try the following solution that worked for me.

Cisco Vpn Not Connecting Could Not Connect To Server
  • Open Services management console by running Services.msc from Run
  • Find the service ‘Cisco AnyConnect Network Access Manager‘.
  • Right click and stop the service.
  • Now Cisco AnyConnect will say ‘NAM service unavailable‘
  • Now Windows will use the native WiFi client to connect to the WiFi
  • When you reboot your system, the NAM service will start and may cause problem again. You can disable this service in Services management console to prevent that.

Cisco Anyconnect Could Not Connect To Server

AnyConnect has settings to disable the NAM feature. But that did not work for me. Even after disabling NAM service, I could not connect to WiFi. Easeus partition master machine code. Windows network icon shows the WiFi connection but gives the error ‘Windows was not able to connect to…‘. I followed the below steps to do this.

  • Opened Anyconnect window and click on Advanced.
  • Clicked on ‘Networks’ tab in the left side pane.
  • Clicked on Configuration tab. Changed the NAM to disabled as shown below.